Installation Guide

ErgoAngleBar

with Optional Toilet Paper Holder

Model #4007-SSB, 4007-SSP, 4007-ORB

PW-94007-76BSS, PW-94007-76PSS, PW-94007-76BRZSS

Owner's Manual

IMPORTANT

Check local code for proper placement of

ErgoAngleBar to meet requirement such

as ADA or ANSI 117.1 Consumer Safety

Requirements.

ERGOANGLEBAR CAN BE MOUNTED

THROUGH SHOWER WALL AND SCREWED

DIRECTLY TO WOOD OR METAL STUD

WHEN APPLICABLE.

INSTALLATION QUESTIONS

Before returning your ErgoAngleBar to the store

or have any question about installation or missing

parts please visit the CUSTOMER CARE area on our

website www.PulseShowerSpas.com.

ALL PICTURES SHOWN ARE FOR ILLUSTRATION PURPOSE ONLY. ACTUAL PRODUCT MAY VARY DUE TO PRODUCT ENHANCEMENT.

TOOLS REQUIRED FOR INSTALLATION

• Electric Drill

• 1/8” wood or metal drill bit

• 5/16” masonry drill bit

• Tape measure

• Screwdriver

• Level

Optional Toilet Paper Holder Included

PAGE 1
ErgoAngleBar with Optional Toilet Paper Holder Model #4007-SSB, 4007-SSP, 4007-ORB PW-94007-76BSS, PW-94007-76PSS, PW-94007-76BRZSS Owner's Manual Optional Toilet Paper Holder Included TOOLS REQUIRED FOR INSTALLATION IMPORTANT Check local code for proper placement of ErgoAngleBar to meet requirement such as ADA or ANSI 117.1 Consumer Safety Requirements.
PAGE 2
Installation Instructions 1 Position mounting flanges and mark hole locations. For wood or solid backing applications drill 1/8” pilot holes through shower wall into wood or metal stud.NOTE: If wall is tiled, drill a 1/8” pilot hole through tile then change to the a 5/16” diameter masonry tile drill bit. 2 Install screws through mounting flange and directly into wood/metal stud or bracing. Use masonry anchors if necessary.