Niagara Wall Mounted Tub Filler Model #3030-WMTF-BN, 3030-WMTF-CH, 3030-WMTF-MB, 3030-WMTF-ORB PW-93030-80TFWBRN, PW-93030-80TFWCP,PW-93030-80TFWBM, PW-93030-80TFWBRZ Owner's Manual
Wall Mounted Tub Filler Please Read The Following Instructions COMPLETELY Before Beginning! Our goal is to ensure your installation goes smoothly and safely. Please read these instructions carefully and follow recommendations for plumbing and mounting. After reading instructions, if you determine you do not have the necessary skills and/or tools, we recommend that a licensed plumbing contractor complete the installation.
Parts Legend 1. 2. 3. 4. 5. 6. 7. 8. Handle Set Screw Set Screw Cover Valve Cover Cartridge Nut Valve Cartridge Tub Filler Body Trim Mounting Plate 9. 10. 11. 12. 13. 14. 15. 16. Threaded Nipple.......................2 Diverter Cartridge Diverter Cartridge Nut Diverter Handle Diverter Handle Pin Spout Handshower Washers......................................3 17. Hose 18. Handshower Holder 19. Glue 20. Nuts................................4 21. Screws............................4 22. Anchors..............
Installation Instructions BEFORE YOU BEGIN Measure the following to ensure your tub filler will fit properly. 3 1 6 in. Behind wall stud Make sure the water supply (hot/cold) line is 6 inches apart from the center of each pipe. 2 Screw nuts onto nipple until the end is flushed with the wall. 4 9” 2.5” Step 1 Step 2 Make sure you leave a 9 inch by 2.5 inch rectangular opening on your finished wall. Step 1: Add plumber's tape to nipple as shown (shorter end of the thread).
Installation Instructions 5 8 Tile Step 1: Mark trim holes on wall with a pencil. Use a level to make sure everything is leveled. Tile 0.75” Studs Trim Add anchors and secure trim with the provided screws. Make sure the finished side of the trim in facing outward 6 Tile Tile 0.75” Studs Trim 9 Make sure you have 0.75 inches on nipple protruding from wall 7 Used the finished nuts. Screw onto nipple flat side first (against trim) and secure.
Installation Instructions 10 12 Step 3 Glue Tape Back of handheld holder Step 1 Step 2 Slide washer onto tub filler connection and screw onto nipples. 11 Finished product Add washers to both ends of hose. Connect hex head end to swivel joint (6) and tapered end to handshower.
Installation Instructions water ON OPERATION: TUB FILLER FUNCTIONS: HANDSHOWER FUNCTIONS: OFF/Cold water ON OFF/Cold Turning tub filler ON, lift valve handle up. For handshower to be OFF the diverter handle should be facing up. The closer to the OFF position, the colder 180° Fold the water will be. 180° Fold Away arm 180° Fold Away arm ON/Hot Cold Hot Hot Cold OFF/Co 180° Fold Away arm While ON, turn handle to the left for HOT and right for COLD.
Usage Care and Maintenance Diverter valve controls the tub filler and handshower. Refer to drawings on "OPERATION" step. To keep your tub filler looking new, wipe down after each use with a soft cotton cloth. Always turn cold water on first to help prevent any accidental burning or scalding; especially for children and elderly. Protect your tub filler from hard water stains and mineral deposits by periodically using an auto spray wax. DO NOT use any part of the tub filler as a support device.
