Installation Instructions

5
Assembly
After Unpacking Your ShowerSpa, Some Assembly Is Required Prior To Installation
Shower Arm Assembly
1. Place escutcheon (3) over threaded end of shower arm (2) and insert through shower arm hole. At back of panel, place silicone gasket (4)
over shower arm and secure with nut (5) to ShowerSpa.
2. Attach 90° elbow/supply line (7) to shower arm (2) ensuring rubber washer (6) is still in hose tting. Do not over-tighten.
Handshower Holder Assembly
1. Insert handshower holder (12) into hole located on side of ShowerSpa, install rubber gasket (4) and secure with nut (5).
2. Secure nut (5) with adjustable wrench if needed.
3. Attach supply line (7) with rubber washer (6) installed to the handshower holder (12).
After ShowerSpa Is Mounted To The Wall
Connect The Handshower
1. Insert washer (6) into hexagon shaped end of handshower hose (13) and attach to threaded outlet of the handshower mount.
Do not over-tighten.
2. Insert washer (6) into tapered end of handshower hose (13) and attach to handshower (14). Insert handshower into holder (12).
Attach Showerhead
1. Insert washer (6) into showerhead (8) and hand tighten onto the shower arm (2).