Owner's Manual

8
Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call [phone].
Bluetooth ™ Speaker Pairing and Use - See WARNING BELOW
Pairing Speaker to Audio Device
• Call [phone] to speak with a customer service representative
Pairing Help
The brake is capable of locking up and skidding the rear wheel if not applied correctly.
Always try and avoid skidding as this could cause you to lose control of the scooter and will cause damage to the
rear tire. Practice using the brake in an unobstructed open area to become familiar with its function and until you
can make smooth, controlled stops.
WARNING:
Repair and Maintenance
Only use the supplied battery charger. If battery charger is damaged discontinue use immediately and replace with a Pulse Performance
Products™ recommended battery charger.
Battery Charger
Wheels and drive system components are subject to normal wear and tear. It is the responsibility of the user to regularly inspect wheels for
excess wear and adjust and replace drive train components as required.
Wheels
Most of the common replacement parts are available for purchase by calling [phone].
Replacement Parts
• Call [phone] to speak with a customer service representative
Repair Help
Before you can use your scooter’s Bluetooth™ speaker, you must pair it with your phone or other audio device by following these simple steps:
Step 1. Make sure your phone or audio device is on, and the Bluetooth™ function is enabled.
Step 2. Turn on your Freewheel 200s Scooter, and listen for the 8 tones, followed by the words “Bluetooth Mode”.
Step 3. Your device should give you an option to PAIR with Bluetooth™ device FWBT200.
Step 4. Allow your device to PAIR. If successful, you will hear 2 confirmation tones that the device is now paired to your scooter’s speaker.
NOTE: After successfully pairing, your device will stay paired until you unpair it from the scooter’s speaker. This allows you to simply
turn the scooter on and off, without the need to follow the steps above again. And remember, if your device is already paired with
another Bluetooth™ product, it will not connect/pair with your scooter’s speaker until that product is turned off or unpaired.
Step 5. Use the controls on your device to listen to your favorite music as you cruise!
NEVER ATTEMPT TO USE THE CONTROLS ON YOUR PAIRED DEVICE WHILE THE
SCOOTER IS IN MOTION. ALWAYS COME TO A COMPLETE STOP IN A SAFE LOCATION BEFORE
ADJUSTING VOLUME, CHANGING SONGS OR PERFORMING ANY FUNCTION ON YOUR DEVICE,
REGARDLESS IF IT IS PAIRED TO THE SCOOTER’S SPEAKER OR NOT. THIS IS FOR YOUR OWN SAFETY
AND THE SAFETY OF THOSE AROUND YOU. FAILURE TO FOLLOW THIS WARNING COULD LEAD TO
LOSS OF CONTROL OF THE SCOOTER RESULTING IN SERIOUS INJURY OR DEATH.
WARNING: