Owner's Manual

5Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call [phone].
Assembly
Tools required: 5 mm hex wrench, 10 mm wrench
Handlebar Steer Tube Assembly
1. Depress the push button located on the
rear of the fork tube and insert the handlebar
steer tube onto the fork tube. The push button
should align with the locator hole in the
handlebar steer tube and lock the steer tube
securely in place. Once the push button pops
out of the locator hole, lift up on the steer tube
to ensure it cannot slide off. If it cannot, then
proceed to step 2.
2. Tighten the bolts with the 5 mm hex
wrench and 10 mm wrench. Tighten bolts
evenly and securely.
4. Locate the 3 small, black clips that are
pre-installed on the trottle cable - they look like this >>>
They slide easily along the cable, and are designed to
be inserted into 1 hole on the scooter neck and 2 holes
on the steering column, to keep the throttle cable located
in a clean, safe position. Simply align each clip with its
respective hole (as shown) and press it firmly into place.
Do not remove clips from the cable before inserting.
Locator Hole
a
c
Anti-Rotation
Hole
b
3. Align handlebars (a) onto the stem tube
cradle (b) and install handlebar clamp (c)
ensuring that the clamp locating pin inserts
into the Anti-Rotation Hole (hole should be
facing upward). Install hardware and tighten
both bolts and nutswith the 5mm hex wrench
and 10mm wrench evenly and securely