User Manual

7
Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call [phone].
Hardware Maintenance
Before You Ride
Brake
Check the brakes for proper function. When you step on the brake it should provide positive braking action. When you apply the brake with the
hub motor activated the brake cut off switch should cut power off to the motor.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken frames are rare, it is possible for aggressive rider to run into a curb or wall and
bend or break a frame. Get in the habit of inspecting your scooter on a regular basis.
Tires
Periodically inspect the wheels for excess wear.
Safety Gear
Always wear proper protective gear such as an approved safety helmet. Elbow pads and knee pads are recommended. Always wear athletic
shoes (lace up shoes with rubber soles), never ride barefooted or in sandals, and keep shoelaces tied and out of the way of the wheels,
motor and drive system.
Battery
Make sure the power switch is turned off whenever the scooter is not in use. Never store the product in freezing or below freezing
temperatures! Freezing will permanently damage the battery.
Before you ride always check and for the following:
Safety Gear
Always wear proper protective gear such as:
• Approved safety helmet. (Helmet may be legally required by local law or regulation in your area.)
• Elbow pads and knees pads
• Long sleeved shirt, long pants
• Gloves
• Lace up shoes with rubber soles.
Brake
Check the brakes for proper function. When you apply the brake with the hub motor activated the brake cut off switch should cut power off to
the motor. Make sure that the brakes are not rubbing when the brake is not being applied. Do not ride the scooter if the brakes are not
functioning properly. Do not touch the brake on the scooter when in use or directly after use as these parts can become extremely hot.
Hub Motor
Make sure that before the hub motor is activated by stepping onto the deck that you are in an open and safe area to ride, you are balanced on
the scooter and have both hands on the handlebar controls. Push start scooter to approximately 3mph while standing on the deck in order for
motor to engage. The scooter must be rolling at 3mph before the motor will engage.
Tires
Inspect the wheels for excess wear and replace if necessary.
Frame, Fork and Components
Always carefully inspect your scooter before you ride. Check for cracks, broken worn or loose components which should be repaired or
replaced before you ride.
Battery
Always make sure the power switch is in the “off” position whenever the scooter is not in use. Never store the product in freezing or below
freezing temperatures. These low temperatures will permanently damage the battery.
NOTE:
Push start scooter to approximately
3mph while standing on deck in order for
motor to engage. The scooter must be
rolling at 3mph before the motor will engage.
Always ensure that you are in a safe open area to ride before you
engage the throttle. Never activate the motor without being on the scooter in a balanced,
ready to ride position with both hands on the handlebar controls.
Failure to follow these instructions may damage your scooter and void your warranty.
WARNING: