User Manual

9Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call [phone].
Repair and Maintenance
WARNING: Turn the power switch “OFF” before conducting any maintenance procedures.
Tools required: 10mm wrench
Adjusting the Brakes
1. To adjust the brake cable thread clockwise
(loosen) or counter clockwise (tighten)
the adjuster barrel on the brake lever.
Only turn the barrel in small increments
until the desired adjustment is reached. If
brake continues to need further adjustment
proceed to the next step.
2. If the brake cable is still either too tight or
too loose use a 10mm wrench to loosen the
brake cable pinch bolt for further adjustment
on the cable. Ensure that the 10mm nut is
securely tightened after the adjustment is
made.
WARNING: The brake could be capable of locking up and skidding the rear wheel if not applied correctly.
Always try and avoid skidding as this could cause you to lose control of the motorbike and will cause damage to
the rear tire. Practice using the brake in an unobstructed open area to become familiar with its function and can
make smooth controlled stops.
Loosen
Tighten