Daim Ntawv Qhia Tus Neeg Siv

PANEL DESCRIPTIONS

1. Power ON/OFF Switch

2. PEAK LED indicates if a connected source level is too high. If the PEAK

LED is RED, reduce the zone input or output level

3. Standby/Zone ON LED- When this LED is BLUE this indicates a zone is not

on or in Standby mode. When this LED is WHITE it indicates that a zone is

1. Stereo line-level Pre-Amp outputs

(Zones 1-6)

2. Mode Switch: Mono/Bridge

3. Speaker Outputs: 50w @ 4 Ohms-

Stereo, 25w @ 8 Ohms-Stereo,

100w @ 8 Ohms-Bridge

4. Source Inputs (Input 1/PA)

5. Status: Used to control external

zone devices

6. IR Outputs to control sources

7. A) PA Trigger IN (Source 1)

B) MUTE In/Control Out: This input

can temporarily mute the system

by connecting this unit to a relay

closure switch on home automation

system or phone system etc. When

switch is on, it will short-circuit the

input and mute the unit.

8. IN/OUT Port: Daisy-chain additional

PA66MK2 units (up to 3 maximum)

9. RS-232 Port

10. Voltage Selector (115v~230v)

11. AC Input (connect included power

cord)

12. Keypad Hub Input (for optional

PA66ACCS)

13. ACG (Automatic Gain Control):

brings low input levels up to a

preset-level

14. Unit ID Switch