Operation Manual

METRONOME MODE

[METRONOME SETTING]

● The flashing digits move quickly if button C or E is kept pressed.

[METRONOME OPERATION]

● If the illuminating light is turned on while the metronome is in use, the metronome

sound stops and then resumes in 3 seconds.

WORLD TIME MODE

● In the enlarged display, “DST” (daylight saving time mark) is not displayed.

● The time differences and use of daylight saving time may change in some areas or

countries when they are so decided by the countries concerned.

ILLUMINATING LIGHT (Electroluminescent panel)

● The electroluminescent panel loses its luminance as the battery voltage gets lowered.

Also, its luminance level decreases gradually with use. After 120 hours of use, the level

decreases by about half.

● When the illuminating light becomes dim, replace the battery with a new one. If the light

remains dim after the battery is replaced, have the electroluminescent panel replaced

with a new one by the retailer from whom the watch was purchased. It will be replaced

at cost.

● While the illuminating light is used, the watch gives out a slight noise. However, this

is not a malfunction.

[TURNING ON/OFF OF BUTTON OPERATION CONFIRMATION LIGHT]

● This function is deactivated automatically in 11 to 12 hours after it is activated.