Operation Manual

23
STOPWATCH MODE
● After 10 hours have been measured, the stopwatch continues measuring from “00”.
If it is left counting for more than 100 hours, it will automatically be stopped.
● Restart and stop of the stopwatch can be repeated by pressing button C.
● Measurement of the lap time and split time can be repeated by pressing button E.
● The lap number counts up to “199”. After “199”, the number is displayed in two digits
such as “00” for 200, “01” for 201, and so on.
Lap time
Split time
Lap No.
● The lap time and split time measured
remain displayed for 10 seconds together
with the flashing lap number. Then, the
display automatically returns to the
measurement in progress.
● Even if the digits are reset to “00” in the stopwatch measurement, the stored data is
not erased and can be recalled unless a new measurement is started.
● Even if the STOPWATCH mode is changed to another while the measurement is in
progress, it continues counting properly. After the stopwatch is used, however, be sure
to reset it as the battery energy is consumed enormously to shorten the battery life.
[MEMORY RECALL FUNCTION]
● In the normal display, the lap number is displayed at the bottom row.
● In the enlarged display, the split time is displayed together with the split number.
● If no measurement is made, “NO DATA” will be displayed when button B is pressed
to activate the memory recall function.