Operation Manual

English

A, C, D or E to return to the TIME/CALENDAR mode, and then set the time/calendar

again.

STOPWATCH MODE

● Restart and stop of the stopwatch can be repeated by pressing button E.

● A “Start-Finish-End” stopwatch operation system is used. The data obtained from the

start till finish of a race is recorded as a block and stored in memory.

● Lap time measured remains displayed for 5 seconds in the upper row. In the lower row,

the lap number is displayed, followed by split time measured. Then, the measurement

in progress appears.

● The time elapsed from the finish of the race until the end of the measurement will not

be included in the measurement.

● Up to 75 measurements can be stored in memory. If more than 75 measurements are

made, the measurements over 75 will not be stored in memory.

● When the memory has become full and a lap time/split time measurement is made,

“FULL” appears below the measured lap time, indicating that the measurement data

is not stored in memory. To check the memory capacity, change the mode to the

MEMORY RECALL mode, which displays the number of storable data.

Lap time

Split time