Use and Care Manual

ASSEMBLY

Adding / Checking Engine Oil (See fig 5)

•

Place pressure washer on a level surface.

•

Carefully add between 500 ml (17oz) of 4-Cycle engine oil (SAE10W30) to empty reservoir until oil reaches

•

Be sure to replace both dipsticks before attempting to start the engine.

•

To check oil, set pressure washer on a level surface, wipe dipstick clean, then reinsert dipstick without re-threading.

FIG 5

Adding Fuel (See fig 6)

•

Set pressure washer on a clean and level surface in an area that is well ventilated.

•

Remove fuel cap.

•

Insert a funnel into the fuel tank and carefully pour gasoline into the tank until fuel level reaches 1.2 inches below the

top of the neck.

FIG 6

CAUTION!