Use and Care Manual

1800 PSI Pressure Washer
11
- Connect the high pressure hose to
the high pressure outlet fitting as
per assembly step 2 and step 4.
- Open the water supply valve completely.
- Before turning the unit on, press the gun trigger to bleed all the
remaining air out of the pump and hose.
- Start the pressure washer by turning the on/off switch to the
on position and squeeze the trigger.
REMINDER: mThe otor does not run continuously, only when thetrigger is
squeezed.
WARNING – Risk injury the unit will start spraying
when trigger is squeezed. When turning the unit off after
use, high pressure still exists inside the hose and unit. Point
the gun in a safe direction and discharge the excess
pressure. NEVER direct the high pressure water stream at
people or animals.
Automatic On / Off
The pressure washer is equipped with an automatic on/off switch.The pressure washer
will only run when the power switch is in the ON position and the trigger on the gun is
OPERATING INSTRUCTIONS
THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY!
DO NOT USE HOT WATER IN THIS PRESSURE WASHER!
Starting Up
After connecting the pressure washer to your cold
water supply, proceed as follows:
-
Make sure that the on/off switch is
in the off position.
- Connect the garden hose with a quick
connect to the inlet fitting.
- Attach the hose to the gun as per
assembly instruction
step #1.
- Insert the adjustable spray nozzle
into the gun as per assembly step
#2.