1800 PSI Pressure Washer Table Of Contents Topic Page # Important Safety Tips, Precautions, Warnings, and Usage Instructions 2-5 Assembly Instructions 6-10 Operating Instructions 11 -13 Detergents 14 Clean-up and Storage 15-16 Cleaning Tips 17-18 Technical Data 18 Troubleshooting Tips 19 Limited Warranty 20- 21 Parts 22- 25 1
1800 PSI Pressure Washer GROUND FAULT CIRCUIT INTERRUPTER (GFCI) This pressure washer is provided with a ground fault circuit interrupter (GFCI) built into the plug of the power supply cord. This device provides additional protection from the risk of electric shock. Should replacement of the plug or cord become necessary, use only identical replacement parts that include GFCI protection. This unit is equipped with a Ground Fault Circuit Interrupter (GFCI).
1800 PSI Pressure Washer IMPORTANT SAFETY PRECAUTIONS WARNING: When using this product, basic precautions should always be followed, including the following: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Read all instructions before using the product. Save all safety instructions. Do not operate the pressure washer when fatigued or under the influence of alcohol or drugs. Risk of infection or injury – do not direct the high pressure water stream at any people or animals.
1800 PSI Pressure Washer 5. 6. 7. 8. 9. Read all instructions included with the mask so you are certain the mask will provide the necessary protection against inhaling harmful vapors. Before starting the pressure washer in cold weather, check all of the parts of the equipment and be sure that ice has not formed. Do not store the unit anywhere that the temperature will fall below 0°C (32° F).
1800 PSI Pressure Washer electrical rating not less than the rating of the product.Examine the extension cord before use. Do not use damaged extension cords! Do not pull on cord to disconnect from the receptacle. Always disconnect by pulling on plug. Keep the cord away from heat and sharp edges. Always disconnect the extension cord from the receptacle before disconnecting the product from the extension cord. WARNING – To reduce the risk of electrocution, keep all connections dry and off the ground.
1800 PSI Pressure Washer ASSEMBLY INSTRUCTIONS Unpacking The Carton After opening the carton, please remove all parts and check them against the following list of components that are included: A. High Pressure Washer B. Gun C. High Pressure Hose D. Adjustable Nozzle E . Two-way Connector F. Water Intake Filter (Pre-Installed) G. Detergent Bottle H. Extension Lance J. Surface Cleaner K.
1800 PSI Pressure Washer Step 1 With wheels oriented as shown, and push them into place. Step 2 With hook oriented as seen, slide the hook on the housing dovetail.
1800 PSI Pressure Washer Step 3 • To attach the handle to the front of machine, firstly align the holes. • Then using 4 screws provide and a screwdriver(no supplied), screw the handle to the power washer from back of machine. Step 4 Take the hose lock to position A to unlock. Attach the high pressure hose to the gun. Then push the hose lock to postion B to lock the fitting.
1800 PSI Pressure Washer B B A A Step 5 • Use adjustable spray nozzle Insert the adjustable spray nozzle into the gun. Push and turn the adjustable nozzle clockwise onto the gun until it is hand tight and to lock it in place. When the pieces are joined properly, you cannot separate the two components by pulling out on the adjustable nozzle. All attachments must be inserted into the gun for proper use.
1800 PSI Pressure Washer Extension Lance Rotary Brush Surface Cleaner Step 6 Attach the hose connector to pressure washer. Before attaching the connector to the male fitting, remove the plastic cap, which is inserted onto the male fitting on the pressure washer before shipping. This plastic cap can be discarded once removed. After both components have been installed, attach the garden hose with connector screw on the pressure washer. Connect the garden hose to the waterspout.
1800 PSI Pressure Washer OPERATING INSTRUCTIONS THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY! DO NOT USE HOT WATER IN THIS PRESSURE WASHER! Starting Up After connecting the pressure washer to your cold water supply, proceed as follows: - Make sure that the on/off switch is in the off position. Connect the garden hose with a quick connect to the inlet fitting. Attach the hose to the gun as per assembly instruction step #1. Insert the adjustable spray nozzle into the gun as per assembly step #2.
1800 PSI Pressure Washer squeezed. When you release the trigger to stop spraying water through the gun, the motor on the pressure washer will automatically shut off. Simply squeeze the trigger again to resume using the washer. To stop using the pressure washer, release the trigger and switch the unit to the OFF position. The unit should be turned completely OFF while not in use or while unattended. Bleeding The Gun It is very important to bleed all the air out of the pressure washer before using it.
1800 PSI Pressure Washer Diagram 2 Diagram 1 Detergent Nozzle The detergent nozzle will allow you to apply many forms of liquid detergent onto the work surface.Detergent application happens at low pressure only. Fill the container with detergent only Do not put any water into the container. The pressure washer will mix water and detergent automatically. When finished appiying the detergent to the work surface, insert the adjustable spray nozzle, and remove the detergent by using the high pressure spray.
1800 PSI Pressure Washer USING DETERGENTS Biodegradable detergents are specifically formulated to protect the environment and your pressure washer. These Detergents will not clog the filter and will protect the internal parts of the pressure washer for a longer life. Step 1 Open the cover of the detergent bottle by twisting it off. Step 2 Fill the detergent bottle with any approved liquid detergent. Close the cover.
1800 PSI Pressure Washer CLEAN-UP AND STORAGE Shutting Down the Pressure Washer WHEN FINISHED USING THE PRESSURE WASHER,FOLLOW THESE STEPS TO SHUT DOWN THE UNIT: • • • • • • • Turn the pressure washer to the OFF position. Turn off the water supply. Before disconnecting high-pressure hose connection, point the gun in a safe direction and discharge the high-pressure water. Disconnect high-pressure hose from the pressure washer and gun. Disconnect garden hose from the pressure washer.
1800 PSI Pressure Washer Winterizing and Long-Term Storage FOLLOW ALL OF THE ABOVE SHUT-DOWN PROCEDURES,ADDING THE FOLLOWING STEPS…. • After disconnecting the water supply, and before disconnecting the high-pressure hose, turn the pressure washer on for 2-3 seconds, until any remaining water in the pump exits. Turn the unit off immediately.
00 PSI Pressure Washer CLEANING TIPS WARNING: ALWAYS TEST THE SPRAY IN AN AREA FREE AND CLEAR OF PEOPLE AND OBJECTS BEFORE YOU AIMING AT THE INTENDED CLEANING SURFACE. Wood and Vinyl Decks Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent reservoir and apply to the area being cleaned at low pressure. For optimal results, reduce your work area to smaller sections and clean each section one at a time.
1800 PSI Pressure Washer Barbecue Grills, Power Equipment, and Garden Tools Rinse the area with fresh water. If using detergent, fill the detergent reservoir and apply to the area being cleaned at low pressure. Allow the detergent to remain on the surface for a few minutes, but do not let the detergent dry. Rinse at high pressure using the fan spray keeping the tip of the spray nozzle at least 1-3 inches from the cleaning surface. Maintain a greater distance from the cleaning area when using a direct spray.
1800 PSI Pressure Washer TROUBLESHOOTING TIPS WHEN THE SWITCH IS IN THE “I” POSITION THE MACHINE WILL NOT START PROBABLE CAUSE SOLUTION Electrical socket is faulty Voltage is inadequate GFCI trips Power cord is not plugged in Check plug, socket, and fuses Check that the voltage is adequate Reset / Try another outlet Plug in power cord THE PUMP DOES NOT REACH ADEQUATE PRESSURE OR FLUCTUATES PROBABLE CAUSE SOLUTION Water Intake Filter is clogged Pump is drawing air Suction valves are clogged/worn Diame
1800 PSI Pressure Washer LIMITED WARRANTY Pulsar Products, Inc. warrants to the original purchaser who uses the product in aconsumer application (personal, residential or household usage) that all products covered under this warranty are free from defects in material and workmanship for one year from the date of purchase. All products covered by this limited warranty which are used in commercial applications (i.e.
1800 PSI Pressure Washer LIMITED WARRANTY (cont’d) THIS WARRANTY DOES NOT COVER: • Merchandise sold as reconditioned, used as rental equipment, or floor or display models.
1800 PSI Pressure Washer 1800 PSI Pressure Washer EXPLODER VIEW 22 23
1800 PSI Pressure Washer PARTS LISTING Parts No.
1800 PSI Pressure Washer PARTS LISTING Parts No. PWE1800K-36-SY PWE1800K-37-SY PWE1800K-38-SY PWE1800K-39-SY PWE1800K-40-SY PWE1800K-41-SY PWE1800K-42-SY PWE1800K-43-SY DESCRIPTION Jet Lance Swivel Nozzle Quick Connector Nozzle Cleaner Soap Bottle Rotary Brush 11# Connector Floor Cleaner 25 QTY.
必须要有封底。此处文字不要印刷！
