SDS

_______________________________________________________________________________
Report No.: SHES181200191801
Date: 2019-03-06
Page 6 of 21
This document is issued by the Company subject to its General Conditions of Service, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms
and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is
advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this
document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be produced except in full, without prior written approval of the
Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law.
Attention: To check the authenticity of testing/inspection report & certificate, please contact us at telephone: [phone], or email: [e-mail]
SGS-CSTC Standards Technical Services (Shanghai) Co., Ltd
201612 t (86-21)61915666 f (86-21)61915678 www.cn.sgs.com
201612 t (86-21)61915666 f (86-21)61915678 e [e-mail]
No. 588 West Jindu Rd, Xinqiao Town, Songjiang District, Shanghai CHINA
中 国·上海·松江区金都西路 588 号 邮编：
Test information:
Possible test case verdicts:
- test case does not apply to the test object:
N/A (Not Applicable)
- test object does meet the requirement:
P (Pass)
- test object does not meet the requirement:
F (Fail)
The tests were done in the Electrical Safety Laboratory of SGS-CSTC in Shanghai.
Test item was received on 2018-12-10
Tests were performed from 2018-12-10 to 2019-01-14.
Ambient temp.: 20 ºC ± 5 ºC
When determining the test conclusion, the Measurement Uncertainty of test has been considered.
General remarks:
"(see Enclosure #)" refers to additional information appended to the report.
"(see appended table)" refers to a table appended to the report.
Throughout this report a comma is used as the decimal separator.
This document is issued by the Company subject to its General Conditions of Service printed overleaf,
available on request or accessible at http://www.sgs.com/en/Terms-and-Conditions.aspx and, for
electronic format documents, subject to Terms and Conditions for Electronic Documents at
http://www.sgs.com/en/Terms-and-Conditions/Terms-e-Document.aspx. Attention is drawn to the
limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document
is advised that information contained hereon reflects the Company’s findings at the time of its
intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is
to its Client and this document does not exonerate parties to a transaction from exercising all their rights
and obligations under the transaction documents. This document cannot be reproduced except in full,
without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the
content or appearance of this document is unlawful and offenders may be prosecuted to the fullest
extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s)
tested and such sample(s) are retained for 30 days only.