User Instructions
www.pulsar.pl PSDC05125T
6
3. Operating status indication.
The PSU is equipped with LED indication of operation status. The presence of power at the outputs of the
PSU is indicated by the illumination of green LEDs on the front panel of the device.
3.1. LED indication
• LED1…LED5 green diodes indicate power at the outputs:
LB5- AUX1…AUX5.
In case of a power loss at the output (fuse activation), an appropriate diode goes out. (L1 for AUX1, L2 for
AUX2 etc.)
4. Operation and use.
4.1 Overload or short circuit at the PSU output.
The AUX1 ÷ AUX5 PSU outputs of the LB5 strips are protected against a short circuit by glass fuses. If a fuse-
assisted protection has been chosen, replace the fuse (of the same parameters) in case of a failure.
4.2 Maintenance.
Any and all maintenance operations may be performed following the disconnection of the PSU from the power
supply network. The PSU does not require performing any specific maintenance measures. However, in case of
significant dust level, clean its interior with compressed air. In case of a fuse exchange, use the replacement of the same
parameters.
WEEE MARKING
According to the EU WEE Directive – It is required not to dispose of electric or electronic
waste as unsorted municipal waste and to collect such WEEE separately.
Pulsar
Siedlec 150, 32-744 Łapczyca, Poland
Tel. (+48) 14-610-19-40, Fax. (+48) 14-610-19-50
e-mail: biuro@pulsar.pl, sales@pulsar.pl
http:// www.pulsar.pl, www.zasilacze.pl