User Instructions

www.pulsar.pl PSAC08246
8
4. Operation and use.
4.1 Overload or short circuit at the PSU output
The AUX1÷AUX8 PSU outputs are protected against a short circuit with glass or polymer fuses. In case of fuse
damage, the replacement of the same parameters is required.
If the polymer fuse-assisted protection has been chosen, there will be an automatic disconnection of the output
voltage indicated by the green diode going out. Then, cut off the load from the PSU output for approx. 1 minute.
If the PSU is loaded with current exceeding Σ6,0A@24V AC (110%for ÷ 150% of S power), there occurs the F
fuse damage in the 230V AC circuit and/or F1÷F8 fuses. In case of a failure, replace the fuse of the same parameters.
4.2 Maintenance.
Any and all maintenance operations may be performed following the disconnection of the PSU from the power
supply network. The PSU does not require performing any specific maintenance measures. However, in case of a
significant dust level, clean the interior with compressed air. In case of a fuse replacement, use one of the same
parameters.
WEEE MARKING
According to the EU WEE Directive – It is required not to dispose of electric or electronic
waste as unsorted municipal waste and to collect such WEEE separately.
Pulsar
Siedlec 150, 32-744 Łapczyca, Poland
Tel. [phone], Fax. [phone]
e-mail: [e-mail], [e-mail]
http:// www.pulsar.pl, www.zasilacze.pl