Replacement Part List

Operation

2. If the OVERLOAD light turns on and the generator stops

producing power, it has been overloaded.

3. Turn off and disconnect all electrical devices and stop the

engine. Compare device requirements to generator rating and

reduce the total wattage of connected devices if necessary.

Move anything that may be limiting generator ventilation away.

4. Check if any circuit breakers have tripped and make sure that

ALL circuit breakers are reset before starting the generator again.

5. Restart the engine and reconnect devices while being careful

to not overload the generator.

Low Oil Indicator

1. If the engine oil level is too low, the LOW OIL light turns on

≤270ml and the engine will automatically shut off.

2. The engine cannot be restarted until the proper amount of oil

has been added. Add the appropriate type of oil until the oil level

is at the proper level. SAE 10w-30 oil is recommended for

general use.

Low Idle Switch

1. Turn the low idle switch ON to limit noise and fuel consumption

for lighter generator loads.

2. Switch low idle OFF to operate engine at full speed when:

• Starting the generator

• A heavy load is applied

Stop The Engine

1. Turn off and unplug all connected electrical loads. Never start

or stop the generator with electrical devices plugged in or

turned on.

2. Push-Button Stop: Press the push-button once to stop the

engine.

Remote Key Stop: Press STOP on the remote start key fob for

0.5 second to stop the engine.

Do not run the engine with too little oil. Engine will shut off if

engine oil level is too low.

NOTICE

OFF

Key Fob

Activation Light

OFF Button

ON Button