Specifications

Owner’s Manual

Operation

NOTE: THE PARTS LISTED ABOVE ARE HELPFUL FOR LOCATING THE

CONTROLS MENTIONED BELOW.

CAUTION: PRIOR TO FIRST USING THE GENERATOR, THE ENGINE MUST BE

FILLED WITH OIL OF A HIGH QUALITY SAE 10W-30 GRADE ENGINE OIL.

TO DO SO, UNSCREW AND REMOVE THE ENGINE’S OIL DIPSTICK LOCATED

AT THE BOTTOM OF THE ENGINE CRANKCASE. FILL THE ENGINE’S

CRANKCASE UNTIL THE OIL LEVEL IS LEVEL WITH THE UPPER MARKED

LINE ON THE DIPSTICK. THEN SCREW THE DIPSTICK BACK INTO

THE OIL FILL HOLE.

Before Starting the Generator

1. Check that the engine power switch is in its

“OFF” position.

2. Before the first use, remove the fuel

tank cap and fill the fuel tank with unleaded

gasoline. When fueling, be sure that the

fuel strainer is in place. Replace the fuel

tank cap. Thereafter, check the engine’s

fuel gauge for the amount of unleaded

gasoline in the fuel tank. If necessary,

refill the fuel tank with unleaded gasoline;

the generator must be turned off and

cooled down before refilling the fuel tank.

k Lever

฀

Pull start

Fuel valve

Choke lever

Control panel

Fuel tank

Fuel Tank Cap