Specifications

7500W Generator

General Precautions (cont’d)

Installation (cont’d)

• If the generator is installed outdoors, it must be weatherproofed and should be soundproofed. It

should not be run outdoors without protection to the generator and wiring conduit.

• The generator weighs 10 lbs (approx). Two or more people should assist when moving or lifting this

oduct. Never lift the generator using the engine or alternator lifting lugs. Connect lifting

equipment to the frame of the generator

•

Before lifting the generator, ensure the lift rigging and supporting structure are in good

condition, and are rated to lift such a load.

• Keep all personnel away from the suspended generator during relocating.

• The supporting oor/ground surface should be level and strong enough to safely hold the weight

of the generator. If the floor/grounded surface is not level, strong cross members should be

placed under the full length of the generator frame at its low side.

• For trailer installation, the generator should be mounted on the center point of the trailer, over

the wheels. The trailer must be capable of supporting the weight of the generator and all

contents (tools, etc.)

• Install sound-and weather-proofing only when it is not raining or snowing to avoid trapping

moisture within the generator’s area.

Mechanical

• Always make sure the power switch is in its “OFF” position. Disconnect the spark plug wire, and

allow the engine to completely cool before carrying out maintenance.

• Check for damaged parts. Before using the generator, any part that appears damaged should

be carefully checked to determine that it will operate properly and perform its intended function.

Check for alignment and binding of moving parts, any broken parts or mounting fixtures, and any

other condition that may affect proper operation technician.

•

The generator is designed with guards for protection from moving parts. In any case, care must

still be taken to protect personnel and equipment from other mechanical hazards when working

around the generator.