Full Product Manual

7500W Generator
Operation (cont’d)
Starting
1. Make sure the electrical powered tools/equipm
that will be used are not plugged into the
generator while the engine is started.
2. Turn the 120 volt AC circuit breaker to its “OFF”
position.
3. Open the fuel valve.
4. Close the choke lever to about 1/8”
clearance.
5. Turn the engine power switch to its “ON”
position.
6. Hold the start handle loosely and pull it
slowly several times to allow the gasoline to flow
into the engine’s carburetor. Then hold the start
handl
e fi
rmly and pull the rope hard and fast.
Pull the rope all the way out, using two hands if
necessary. If necessary pull the rope several
ti
mes until the engine starts.
7. Allow the engine to run for several seconds. Then,
open the choke lever all the way.
15
7\[[OLLUNPULZ^P[JOVU[OL¸9<5¹WVZP[PVU
;OLLUNPULZ^P[JOLUHISLZHUKKPZHISLZ[OLPNUP[PVU
Z`Z[LT
ON
OFF: To stop the engine
ON: To run the engine
E-Start: To start the engine
;OLM\LS]HS]LPZSVJH[LK\UKLY[OLM\LS[HUR>OLU
[OL]HS]LSL]LYPZPU[OL65WVZP[PVUM\LSPZHSSV^LK
[VMSV^MYVT[OLM\LS[HUR[V[OLJHYI\YL[VY)LZ\YL
[VYL[\YU[OLM\LS]HS]LSL]LY[V[OL¸6--¹WVZP[PVUHM[LY
Z[VWWPUN[OLLUNPUL
;VZ[HY[HJVSKLUNPULTV]L[OLJOVRLSL]LY[V[OL
¸:[HY[¹WVZP[PVU;VYLZ[HY[H^HYTLUNPULSLH]L[OL
JOVRLSL]LYPU[OL¸9<5¹WVZP[PVU
;OLJOVRLSL]LYVWLUZHUKJSVZLZ[OLJOVRL]HS]LPU
[OLJHYI\YL[VY
;OL¸:[HY[¹WVZP[PVULUYPJOLZ[OLM\LSTP_[\YLMYVT
Z[HY[PUNHJVSKLUNPUL
E-start
E-start
;OL¸9<5¹WVZP[PVUWYV]PKLZ[OLJVYYLJ[M\LSTP_[\YL
MVYVWLYH[PVUHM[LYZ[HY[PUNHUKMVYYLZ[HY[PUNH^HYT
LUNPUL
ON
6--
¸:[HY[WVZP[PVU¹
*OVRL3L]LY
(This recoil starting method only be used when E-start does not work.)
Also this generator can also be started with recoil start.