Operation Manual

22
English
ILLUMINATING LIGHT (Electroluminescent panel)
● The display remains illuminated if button B is kept pressed.
● When button B is pressed in the calendar or blank display of the TIME/CALENDAR
mode, the time/calendar display is shown while the display is illuminated.
● The electroluminescent panel loses its luminance as the battery voltage gets lowered.
Also, its luminance level decreases gradually with use.
● When the illuminating light becomes dim, replace the battery with a new one. If the light
remains dim after the battery is replaced, have the electroluminescent panel replaced
with a new one by the retailer from whom the watch was purchased. It will be replaced
at cost.
● While the illuminating light is used, the watch gives out a slight noise. However, this
is not a malfunction.
● With each press of button C or D, one minute is advanced or moved back, respectively.
The digits move quickly by keeping the respective buttons pressed.
● If the watch is left untouched in the SINGLE-TIME ALARM mode, it will automatically
return to the TIME/CALENDAR mode in 20 to 30 seconds.
● The single-time alarm rings differently from the regular alarm.
● To check the alarm time you have set, press button C in the TIME/CALENDAR mode
to show the SINGLE-TIME ALARM mode.