Operation Manual

32
NECESSARY OPERATION AFTER BATTERY CHANGE
When the battery is replaced, the time information stored in the
built-in IC and the time indicated by the hands do not correspond
with each other. Before using the watch, therefore, be sure to
adjust the hand position, following the procedure in “ADJUSTING
THE HAND POSITION”.
RESETTING THE BUILT-IN IC
In case any of the hands should move improperly, follow the
procedure below to adjust the hand movement.
1. Turn the crown to set the mode indicator to “TIME”.
2. While pressing “A” and “B” simultaneously, turn the crown to
change the mode to “TIME ” or “CHRONO”.
3. Turn the crown to set the mode indicator to “→ Ø← ”.
Then adjust the hand position, following the procedure in
“ADJUSTING THE HAND POSITION”.