Data Sheet

wyjście TAMPER : przewody 30cm
Tel. [phone], fax: [phone], www.pulsar.pl, e-mail: [e-mail]
SPECIFICATIONS:
Supply voltage 27,6V DC
Current consumption 50mA max.
Voltage of low battery indication U<23V +/- 3%
Technical outputs:
- EPS; output indicating AC power
failure
- PSU; output indicating DC
absence/PSU failure
- LoB output indicating low battery
voltage
- relay type: 1A@ 30VDC/50VAC, time lag: approx. 10s.
- OC type, 50mA max., normal status: L (0V) level, failure: hi-Z level,
time lag: 10s.
- relay type: 1A@ 30VDC/50VAC
- OC type, 50mA max., normal status: L (0V) level, failure: hi-Z level
- relay type: 1A@ 30VDC/50VAC
- OC type, 50mA max., normal status: (U
BAT
>23V): L (0V),
failure: (U
BAT
<23V): hi-Z level
Module does not feature a battery detection function. In the case of no
battery or non battery connected, the output is in the normal mode.
LED indication :
- presence of AC power
– presence of DC voltage at the
PSU output
- battery voltage level
- red LED. Under normal status (AC supply) the diode is permanently
illuminated. The absence of AC supply is indicated by the AC diode
going out.
Caution: the LED indicates absence of AC power if the loss lasts
minimum 10s.
- green LED indicates DC power at the PSU output. Under normal
status the diode is permanently illuminated. In case of a short circuit
or an overload, the diode is off.
- green LED indicates battery voltage level. Under normal status (U
BAT
> 23V) the diode is permanently illuminated. In case of decrease of
battery voltage (U
BAT
< 23V) the diode is off.
Operating conditions temperature: -10
o
C÷40
o
C, relative humidity: 20%...90%, without
condensation
Dimensions L=116, W=56, H=27, H1=31 [+/- 2mm]
Net/gross weight 0,11/0,15 kg
Connectors Ф0,41÷1,63 (AWG 26-14)
MPSB series power supply module
Automation module PSB27,6V DC
Pulsar
®