User Guide

ENGLISH
Operation
Installing thermal imaging module on the optical device
•
Remove the eyepiece cover (2).
•
Select the Ring Adapter (15) (sold separately) with the insert (14) of the
desired diameter depending on the outer diameter of the lens of your optical
device (13) (see table). The designation 42 mm / 50 mm / 56 mm in the name
of the adapter means the lens diameter of the optical device.
Selection table for optical device inserts
Ring Adapter
model
The internal diameter of the insert needs to match the outer diameter of the
objective lens housing of the daylight optical device it is being installed on.
Insert internal diameter, mm
Suitable for lens housing of daylight optical
devices with an outer diameter of, mm
PSP Ring
Adapter 42 mm
45.5 45.5
46 46
46.5 46.5
47 46.7-47.6
48 47.7- 48.6
49 48.7-49.6
50 49.7-50.6
PSP Ring
Adapter 50 mm
51.6 51.6
53.4 53.4
55 54.7-55.6
56 55.7-56.6
57 56.7-57.6
58 57.7-58.6
59 58.7-59.6
PSP Ring
Adapter 56 mm
60 59.7-60.6
61 60.7-61.6
62 61.7-62.6
63 62.7-63.6
64 63.7-64.6
65 64.7-65.6
•
Screw together the Ring Adapter (15) and the thermal imaging module along
the threads of the mounting area (20) until it stops. Then untighten a little
(no more than one turn) so that the lever (19) is on the right side (see Figure).
•
Evenly tighten the screws (16) until the ball joint grips in the Ring Adapter (15).
•
Apply 2-3 strips of double-sided tape to the outer surface of the insert of
your choice (14).
•
Push the insert (14) of your choice into the Ring Adapter (15) until it stops.
•
Move the lever (19) to the OPEN position.
•
Before installing the Ring Adapter (15) onto the optical device, it is
recommended to degrease the lens body of the optical device (13).
•
Mount the Ring Adapter (15) with the insert (14) onto the lens of the daylight
optical device (13) as far as it will go.
•
If the Ring Adaptor (15) with the insert (14) selected according to the table
cannot be mounted onto the lens (10), follow the steps below:
- Loosen the locking screw (17) with a 2mm Allen key.
- Untighten the screw (18) with a hex wrench (S = 4mm) until the Ring
Adaptor with the insert can be mounted onto the lens (13).
•
Move the lever (19) from its initial OPEN position to the CLOSE position.
•
Loosen the locking screw (17) with a 2mm Allen key, if it hasn’t been done
before.
4