Operating instructions

www.pulsar.pl INTW
15
Reset the Wi-Fi interface again. To do that, press the „Reset” button on the module or simply disconnect
the power supply for a few seconds. After the reset, the connection between the interface and the router should be
reestablished (the yellow LED is permanently illuminated).
The connection between the Wi-Fi interface and the power supply requires checking whether the serial port
communication parameters are the same.
5. Configuration of power supplies.
5.1 Configuration of power supplies of the PSBEN series with LCD display.
The PSU fitted with LCD display enables setting the communication parameters of the serial port from the
LCD panel. To enter the setup mode, press the „SET” button from the main screen.
- use the „<” or „>” buttons to display the PSU menu
- confirm by pressing the „SET” button
- use the „<” or „>” buttons to display the Transmission menu
(The Transmission menu is at the bottom of the screen)
- press the „SET” button, the prompt will appear at the end of the line
- use the „>” or „<” buttons to set the 19.2k 8E1
- confirm by pressing the "SET" button