User Instructions

www.pulsar.pl INTRE
12
5.2 Configuration of power supplies of the PSBEN series with LED display.
The PSU fitted with LED display enables setting the communication parameters of the serial port from the
LED panel. To enter the setup mode, simultaneously press the „<,>” rightmost and leftmost buttons on the LED
panel.
- simultaneously press the „<,>” rightmost and leftmost
- the „tSt” parameter will be displayed
- press the right arrow „>”
- the „tSt” parameter will be displayed
- press „OK.”
- The information about the transmission speed
will be displayed
- use the „<” or „>” buttons in order to set the required
transmission speed,
- confirm by pressing „OK”
- the „trS” parameter will be displayed
- press the right arrow „>”
- na the „trP” parameter will be displayed
- press „OK.”
- The information about the parity of the transmission
will be displayed
- use the „<” or „>” buttons in order to set the
„8E1” parameter
- confirm by pressing „OK.”
- Simultaneously press the „<,>” rightmost and leftmost
buttons to complete the configuration procedure