User Instructions

www.pulsar.pl INTRE
10
4.5 STEP 4 – Setting the serial port parameters – the “Serial port” tab.
In the "Serial port" tab, set the parameters responsible for the communication between Ethernet interface
and the PSU as shown in the picture below.
Fig. 8. Setting the serial port communication parameters.
If the PSU does not support the 115 200 baud communication speed or other communication parameters
are set, enter the parameters in the „COM port settings” window so that they match the parameters set in the
power supply.
The maximum available communication speed supported by a given power supply unit and other
communication parameters should be checked in the PSU menu, see Chapter 5.
Once set, press the “Apply” button.
Once all the above settings (steps 1-4) are entered, restart the module by pressing the "Restart" in
the PowerConfig or disconnect the power supply.