User Instructions

www.pulsar.pl INTE-C
18
4.11.3 Interface INTE-C – Network.
In the „Network” field, the network parameters enabling communication with the PSU can be accessed.
Fig. 24. Network settings.
DHCP – automatic IP address assignment. Upon selection of the option, the PSU, each time when power
is switched on, will have an IP address automatically assigned from the pool of free server
addresses. Fields of the following parameters: IP Address, Mask, Gateway, are inactive.
IP address – place for entering the fixed IP address. When selecting this option, enter a free and available web
address.
Mask – place for entering the IP subnet mask. It is usually 255.255.255.0
Gateway – network gateway address. Address usually enabling access to the Internet or communication with
computers outside the local network.
HTTP port – number of the web browser port. The default value for http is 80.
Modbus mode – mode of the modbus protocol: TCP or TCP over RTU.
Modbus port – number of the port through which the modbus protocol is sent. The default value TCP = 502 for
TCPoverRTU = 2101.
In order to confirm the introduced changes, press „Save".
4.11.4 Interface INTRE-C – Date and time.
In the „Date and Time” field, a window appears in which the date and time of the system clock of the
interface may be set. Setting correct date and time is important for keeping chronology of events stored in internal
memory.
Fig. 25. Date and time settings.
Device time – current system clock time of the PSU.
Browser time – current browser time of the local computer.
Set the browser time – upon selection, the PSU time is synchronized with the browser time.