User Instructions

www.pulsar.pl EN54C-LCD RED POWER plus
28
– confirm by pressing „SET” button
– use „<” or „>” buttons to enter first digit
– confirm by pressing „SET” button
– use „<” or „>” buttons to enter second digit
– confirm by pressing „SET” button
– use „<” or „>” buttons to enter third digit
– confirm by pressing „SET” button
– use „<” or „>” buttons to enter fourth digit
– confirm by pressing „SET” button
If entered password is wrong, following message will be displayed:
Fig. 23. Message after entering a wrong password.
After entering correct password, it is possible to access settings. If no buttons are pressed within 5 minutes,
PSU settings will be locked automatically.
8.1.2. Changing password.
After entering correct password, it is possible to change it. To do this, choose a password that will be
changed (user’s password or service password) and enter new one.
8.1.3. Disabling the password
If password is not required, it can be turned off. Access to settings will not be locked after 5 minutes of inactivity.
To disable password, type „0000” as a new password.
User password „0000” unlocks access from user level.
Service password „0000” unlocks access from installer level.