User Instructions

www.pulsar.pl AWZ632

Environmental class

Operation temperature

-10ºC...+40ºC

Storage temperature

-20ºC...+60ºC

Relative humidity

20%...90%, no condensation

Sinusoidal vibrations during operation:

Unacceptable

Surges during operation

Unacceptable

Direct insolation

Unacceptable

Vibrations and surges during transport

According to the PN-83/T-42106 standard

2. Mounting.

2.1. Requirements.

The enclosure should be mounted by a qualified installer, holding relevant (applicable and required for a

given country) permits and licenses for low-voltage installations. The device shall be mounted in confined spaces

(in accordance with the 2nd environmental class) with normal air humidity (RH=90% max. without condensation)

and the temperature from -10°C to +40°C. In order to meet the requirements of LVD and EMC directives, the rules

for power supply, enclosures, shielding, and cable routing, depending on application, must be observed.

2.2. Installation procedure.

1. Connect the battery to the BAT socket of the controller, paying attention to polarity.

2. Place the batteries e.g. at the bottom of the RACK cabinet, ensuring adequate ventilation.

3. Connect the battery controller to the uninterruptible power supply with the appropriate battery and charging

circuit protection.

4. Close the enclosure, cabinet, etc. once the tests and operation control are completed.

3. Indication of operation of the battery controller.

3.1. Optical indication.

The controller is equipped with LED light at the front panel:

RED LED:

 ON/blinking – Indicates a failure (Table 6)

 OFF – No errors/normal operation

3.2. Technical output.

The controller is fitted with the ALARM technical output of collective failure. The collective failure can be

triggered by the events presented in Table 6.

Fig. 6. The electrical diagram of the ALARM output of collective failure.

CAUTION! In Fig. 6 the set of contacts shows a potential-free status of the relay which corresponds

to a failure.

3.3. Acoustic indication.

The failure status is also signaled acoustically by means of a piezoelectric indicator (in accordance with

Table 6). Acoustic indication can be disabled with an ON/OFF switch .

Switch in the upper position, the indication is ON

Switch in the lower position, acoustic indication is OFF

Table 6. Table of errors