Data Sheet

A RA D-4 v.1. 0/I
Tel. [phone], Fax. , www.pulsar.pl, e-mail:[e-mail]([phone]
EN
RACK 19" enclosures
Pulsar
®
INTENDED USE
.
The metal RACK-Security enclosure is designed for mounting the alarm control panel and the input/output modules
in free-standing RACK19” cabinets with depths in the range from 800 to 1000mm. It consists of two elements
is used to switch between the YTDY 6x0,5 cable with copper cores and the elastic cable
supplying signals and power to the control panel
– alarm control panel and input and output modules are mounted in this
section - with a space for battery, transformer, and the ARAW45 fan (transformer and fan are not
included
Both and rails - selected depending on the depth of a RACK cabinet - constitute the load
bearing part of the enclosure (not included). The enclosure is fitted with printed circuit boards (PCB) allowing
connection of signal, power and control cables. Each of the boards has pairs of terminals designed to operate at a
voltage of 30VDC and a maximum current of In addition, each one is fitted with the 230VAC power board. The
enclosure is fitted with 3 tamper switches
1. Pulling out the enclosure from RACK profiles
2. Enclosure opening
3. Patch Panel opening
Universal holes in the enclosure allow mounting of control panels and expansion modules of the following
companies DSC, PARADOX, RISCO, SATEL, PYRONIX, CROW, ROGER
:
17Ah
).
6
8
1,5A
:
:
1.
2.
Patch Panel
Pull out enclosure with a 4U height
.
ARAS800 ARAS1000
CODE:
NAME:
ARAD-S4 v.1.0/I
Security enclosure 4U/400mm/48/17Ah for RACK 19" cabinets two-level