Operation Manual
English
English
2524
CARE OF CASE AND BRACELET
To prevent possible rusting
of the case and bracelet
caused by dust, moisture and
perspiration, wipe them
periodically with a soft dry
cloth.
Light activities will not affect
your watch, but be careful not
to drop your watch or hit it
against hard surfaces, as this
may cause damage.
SHOCKS & VIBRATION
Be careful not to expose the
watch to solvents, mercury,
cosmetic spray, detergents,
adhesives or paints.
Otherwise, the case,
bracelet, etc. may become
CHEMICALS
discolored, deteriorated or damaged.
Your watch will be adversely
affected by strong magnetism.
Keep it away from close
contact with magnetic objects.
MAGNETISM
N
S
It is recommended that the
watch be checked once every
2 to 3 years. Have your
watch checked by an
AUTHORIZED PULSAR
PERIODIC CHECK
DEALER or SERVICE CENTER to ensure
that the case, crown, buttons, gasket and
crystal seal remain intact.
2 - 3
Years
PRECAUTION REGARDING
CASE BACK PROTECTIVE FILM
If your watch has a protective
film and/or a sticker on the
case back, be sure to peel
them off before using your
watch.
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the
crown is pushed in completely.
Do not operate the crown when the watch is wet or in water. If used in sea water,
rinse the watch in fresh water and dry it completely.
* When taking a shower with the water resistance 5 bar watch, or taking a bath with
the water resistance 10, 15 or 20 bar watch, be sure to observe the following:
• Do not operate the crown when the watch is wet with soapy water or shampoo.
• If the watch is left in warm water, a slight time loss or gain may be caused. This
condition, however, will be corrected when the watch returns to normal
temperature.
NOTE:
Pressure in bar is a test pressure and should not be considered as corresponding
to actual diving depth since swimming movement tends to increase the
pressure at a given depth. Care should also be taken on diving into water.
TEMPERATURES
+60°C
-10°C
Do not leave your watch in very low
temperatures below –5° C (+23°F) for
Your watch works with
stable accuracy within a
temperature range of 5°
C and 35°C (41°F and
95°F).
a long time since the cold may cause
a slight time loss or gain.
However, the above conditions will
be corrected when the watch returns
to normal temperature.
NPWA50_E 05.4.19, 9:10 AMPage 24-25 Adobe PageMaker 6.5J/PPC