Owner's manual

91
10. Factory Default Values
CALIBRATION
Pump Flow 1-Point Calibration on PULSAR at Rated Flow and Pressure.
Analog Input 4.0 - 20.0mA @ 100% Ratio
Analog Output 4.0 - 20.0mA @ 100% Ratio
DIAGNOSTICS
Alarms Cleared
DATE/TIME
Date Format MM/DD/YY
Time Format 24:00
Daylight Savings Time No
ANALOG INPUT
Enabled – Number of input channels enabled is one.
Failure Mode channel #n Freeze at last signal / Restore to Analog Mode/ Error message enabled
Sample Average channel #n 20 Samples
Sample Update channel #n 20 Samples (5.0 Seconds)
ANALOG OUTPUT
Stroke and Speed setting Calibrated Stroke and Speed combined
END POINT & PRIORITY
Stroke Minimum 0%
Stroke Maximum 100%
Speed Minimum 10%
Speed Maximum 100%
Priority Speed
LEAK DETECTION
Failure Mode Inactive
LEVEL INPUT
Failure Mode Inactive
DIGITAL OUTPUT
Run/Stop Normally Open
MOTOR THERMOSTAT
Input Enabled
Switch Normally Closed
Motor Off
Alarm
Restore to:
On
Motor On
OVER TEMPERATURE
Error Message Enabled
POWER FAILURE
Failure Mode During power up – Motor Off
Wrong Voltage Hard Shutdown
ALARM RELAY
Relay Output Normally Open
SECURITY
Remains as previously set