Owner's manual

58

End Point Set Up procedure
1. Press [MENU] to enter the {–MENU–} sub-system. Press [UP] or [DOWN] until {–MENU– / END
POINT} is displayed.
2. Press [ENTER] to display the {STROKE END POINT / MINIMUM = XXX%} screen.
STROKE END POINT
MINIMUM = XXX%
Press [UP] or [DOWN] to set the value. Press [ENTER] to accept your setting.
3. The {STROKE END POINT / MAXIMUM = XXX%} screen is displayed.
STROKE END POINT
MAXIMUM = XXX%
Press [UP] or [DOWN] to set the value. Press [ENTER] to accept the setting.
4. The {SPEED END POINT / MINIMUM = XXX%} screen is displayed.
SPEED END POINT
MINIMUM = XXX%
Press [UP] or [DOWN] to set the value. Press [ENTER] to accept the setting.
5. The {SPEED END POINT / MAXIMUM = XXX%} screen is displayed.
SPEED END POINT
MAXIMUM = XXX%
Press [UP] or [DOWN] to set the value. Press [ENTER] to accept the setting.
6. The {PRIORITY SPEED} screen is displayed.
7. Press [UP] or [DOWN] to set the priority to either {SPEED} or {STROKE}.
PRIORITY
SPEED
-or -
PRIORITY
STROKE
Press [ENTER] to accept your selection.
8. The {FLOW RANGE} screen is displayed. This represents the available Flow Range based on your
settings. Press [ENTER]
FLOW RANGE
1.0% – 90.0%
9. The {CONFIRM CHANGE} screen is displayed.
CONFIRM CHANGE
YES
If you do not want to confirm these changes, press [DOWN] to display the {CONFIRM CHANGE =
NO} screen.
CONFIRM CHANGE
NO
In either case confirming or not confirming, press [ENTER] to complete the action.
At this point, you are returned to the {–MENU– / END POINT} screen.
7.2.9 Leak Detection Failure Set Up
This sub-menu allows you to configure the DLCM to interact with a PULSAlarm Leak Detection
Diaphragm. You can modify the way the DLCM responds to a diaphragm rupture. The following
responses are available:
−
Shut the motor off,
−
Trigger an alarm relay,
−
Shut the motor off and trigger an alarm relay,
−
Have no interaction with the Pump Motor or Alarm Relay other than log the diaphragm failure
and display a message on the LCD display (this message is displayed until a key on the keypad is
pressed).