Owner manual

80
10. Factory Default Values
CALIBRATION
Pump Flow 1-Point Calibration on PULSAR at Rated Flow and Pressure.
Analog Input 4.0 - 20.0mA @ 100% Ratio
Analog Output 4.0 - 20.0mA @ 100% Ratio
DIAGNOSTICS
Alarms Cleared
DATE/TIME
Date Format MM/DD/YY
Time Format 24:00
Daylight Savings Time No
ANALOG INPUT Enabled – Number of input channels enabled is one.
Failure Mode Freeze at last signal / Restore to Analog Mode/ Error message enabled
Sample Average 20 Samples
Sample Update 20 Samples (5.0 Seconds)
LEAK DETECTION
Failure Mode Inactive
LEVEL INPUT
Failure Mode Inactive
DIGITAL OUTPUT
Run/Stop Normally Open
MOTOR THERMOSTAT
Input Enabled
Switch Normally Closed
Motor Off
Alarm
Restore to:
On
Motor On
OVER TEMPERATURE
Error Message Enabled
POWER FAILURE
Failure Mode During power up – Motor Off
Wrong Voltage Hard Shutdown
ALARM RELAY
Relay Output Normally Open
SECURITY Remains as previously set
NUMBER FORMAT
Separators X , XXX . XX (Comma / Decimal)
Position PULSAR dependent (e.g., 9.99999, 0.999999, etc.)
Factory set to match pumphead size. Refer to Factory
Decimal Position Settings below.
All units are dispalyed.
CONTRAST Restored to initial Factory setting
SERIAL COMM
Net Address Disabled