Owner manual

96
5. Remove the Tachometer Sensor Input Cable on the Field Wiring Board.
a) Disconnect the wire (typically brown) connected to Pin 1 of J10.
b) Disconnect the wire (typically blue) connected to Pin 2 of J10
6. Disconnect the Tachometer Sensor Conduit Assembly nut from the Tachometer Sensor Conduit
Assembly and remove the Conduit Assembly and Tachometer Sensor wire from the DLC housing.
Figure 24 – Accessing the Tachometer Sensor Conduit
O Perform steps 5 and 6 only if there is a Tachometer installed. If there is no Tachometer installed, go to step
7 on the next page.