Owner's manual

43
NON-FATAL ERRORS: The pump and controller can still be run while these conditions exist.
The Red LED will flash and the error will flash on the screen. The Red LED and error message
will cease once the error condition has been corrected.
SOFTWARE Fault
Error = ####
Software related problem, record error number and consult
factory
Hardware fault
Error = ####
Hardware related problem, record error number and consult
factory
CONSULT factory
Error = ####
Unidentified error, record error number and consult factory
USER NOTIFICATIONS: These are errors in setup or calibration. They will display on the
screen for several seconds. They can be corrected by properly completing the procedure
involved.
Cannot access
With motor on
User is trying to change a setting that cannot be changed
while the pump is running
Current delta
Out of range
Not enough difference between high and low signals during
an analog input signal calibration (min 3 mA)
No remote
Control
User is trying to activate the AUTO mode, but there is no
remote input (mA signal or remote on/off) to the controller
.
For unlisted or numbered error codes, consult the factory for assistance.