Owner's manual

11.1.2 Clearing Error Log Entries

Any of the entries in the Error Log may be cleared while viewing by pressing the ENTER key. If the problem

is recurring or still present it may not be clearable.

11.2 Error Messages

The following table gives an example of these messages and when you can expect them to be displayed.

Message Displayed When:

FATAL ERRORS: The pump and controller will not run while one of these error conditions

exists. The Red LED will blink and the error message will flash on the screen. Users can access

the menu system by pressing the MENU key. The red LED and the message will cease when the

error condition has been corrected.

Analog Input #X

Out of Range

The analog input is less than 2.4 mA or greater than 24 mA

ALARM

LOW LEVEL

The level monitoring input has triggered

ALARM

AC DRIVE FAULT

Internal fault

ALARM

MOTOR ERROR

The MPC VECTOR has detected that the motor shaft is not

rotating at the expected speed

COMMUNICATION

ERROR

Communication error exists between the MPC VECTOR

controller and the keypad/display module

Continues next page…