Owner's manual

iv
8.2.1 “WET” Analog Input Calibration (with a field signal) ...................................................... 24
8.2.2 “DRY” Analog Input Calibration (keypad only, no signal present)................................ 26
8.3 Analog Output Calibration ..................................................................................................... 28
8.4 PulsaGuard Pump Protection ................................................................................................ 30
8.4.1 PulsaGuard Calibrations, using Flow Meter Feedback................................................... 30
8.4.2 PulsaGuard Calibrations, no Flow Meter Feedback ........................................................ 31
8.5 Display Contrast Adjustment................................................................................................. 32
8.6 Tuning the Control Algorithm ................................................................................................33
9. FLOW METER INPUT .............................................................................................................................36
9.1 Flow Meter Installation ........................................................................................................... 36
10. MOTOR PARAMETER SETUP AND TUNING .............................................................................................. 38
11. ALARM AND ERROR MESSAGES ............................................................................................................ 41
11.1 Error Log .................................................................................................................................. 41
11.1.1 Viewing the Error Log ......................................................................................................... 41
11.1.2 Clearing Error Log Entries ................................................................................................. 42
11.2 Error Messages ....................................................................................................................... 42
12. SPECIFICATIONS................................................................................................................................... 44
13. MODEL IDENTIFICATION ........................................................................................................................ 47
14. MENU MAPS......................................................................................................................................... 48
15. FACTORY DEFAULT VALUES ................................................................................................................. 51
16. RETRIEVAL OF SETUP INFORMATION .....................................................................................................51
17. SPECIAL KEY PRESS ACCESS............................................................................................................... 51
18. TROUBLESHOOTING GUIDE ................................................................................................................... 52
19. SPARE PARTS ......................................................................................................................................53
20. APPENDIX 1, HANDHELD WIRING...........................................................................................................54
20.1 Removal and Connection of the Cable from the Handheld: ...............................................54
20.2 Removal and Connection of the Cable from the Base Unit:...............................................55
21. APPENDIX 2, PID THEORY AND ADJUSTMENT ........................................................................................ 58
21.1 PID Controller Theory:............................................................................................................ 58
21.2 Three Control Components: .................................................................................................. 60
21.3 PID Basic Summary, what happens when I… ...................................................................... 61
21.4 Putting it all together to run the MPC Vector ....................................................................... 62
21.5 Troubleshooting...................................................................................................................... 63