Instruction Manual

3
2. Installation
2.1 Assembly
 If your DGF is shipped to you unassembled, perform the following: (If you ordered the
assembled version go to section 2.2 – Electrical Wiring.)
FAILURE TO FOLLOW THESE WARNINGS AND ASSEMBLY INSTRUCTIONS COULD RESULT
IN SERIOUS INJURY OR DEATH
!
• Read all instructions carefully before assembly.
• Check all connections to ensure they are tight before applying pressure to the system.
• Wire in accordance to applicable electrical codes.
• Never subject components to full water immersion.
• Never attempt to move this system when the tank is full.
• DO NOT apply lateral force to the tank. The tank can tip spilling the contents.
• When filling the tank use care to prevent spillage or splashing on the wiring or tank cover.
• This system is designed for feeding Ethylene Glycol into pressurized closed loop systems.
• DO NOT run pumps dry.
• DO NOT exceed rated pressure of 80 psi.
DO NOT DEVIATE FROM THESE ASSEMBLY INSTRUCTIONS. QUALIFIED CUSTOMER
SERVICE REPRESENTATIVES CAN BE REACHED AT THIS TOLL FREE NUMBER IF
ASSISTANCE IS NEEDED
: 1 [phone].
2.1.1 Tools Required For Assembly
• Phillips head screw driver.
• Adjustable wrench.