Troubleshooting guide

iv
Conventions
For the remainder of this bulletin, the following Conventions are in effect.
A WARNING DEFINES A CONDITION THAT COULD CAUSE DAMAGE TO BOTH
THE EQUIPMENT AND THE PERSONNEL OPERATING IT
. PAY CLOSE
ATTENTION TO ANY WARNING
.
Notes are general information meant to make operating the equipment easier.
Tips have been included within this bulletin to help the operator run the
equipment in the most efficient manner possible. These “Tips” are drawn
from the knowledge and experience of our staff engineers, and input from the
field.
Revision History:
Rev E (3-25-05)
- Section 1.1 Description, added 3-phase vs. single-phase info
- Change description of digital output specification
- New figure 2 (pump mounting)
- Updated analog in, analog out, and flow calibration instructions
- Update error handling text, Section 9
- Add specifications for voltage range and ELCB’s
- Add safety warnings about inrush current and capacitor discharge throughout
Rev F (7-25-06)
- Added nametag diagram and note on proper input voltage selection on page 9
- Added section 8.5 on adjusting motor base frequency
- Added sample digital output diagram in section 5.3.4
Rev G (11-15-06)
- Changed address information to SPO Punta Gorda front and back covers
- Identified analog input #2 as not yet available, Sections 5.3.4 and 7.1
Rev J (9-26-07)
- Added clarification on digital output capability, sections 1.2, 5.3.4, and 7.4
- Motor information added, sections 1.2, 1.3, and 11
- Added missing step in calibration instructions, section 8.1.1