Troubleshooting guide

13. Factory Default Values

Parameter Factory Set Value

Digital Input #1 INACTIVE, normally closed

Digital Input #2 INACTIVE, normally closed

Analog Input #1 INACTIVE

Analog Input #2 NOT AVAILABLE this revision

Digital Output #1 STROKE Indication, normally closed

Digital Output #2 AUTO/MANUAL Indication, normally closed

Digital Output #3 Alarm Indication, normally closed

Security Code Default = 0000

Language ENGLISH

MODE Local (Manual)

UNITS GPH (gallons per hour)

14. Retrieval of Setup Information

Users can access the system setup : information menu, which will list the following

data, this may be helpful in troubleshooting:

 Controller software revisions

 Pump serial number

 MPC model number

 Pump maximum flow

 Pump maximum speed

15. Special Keypress Access

In This SCREEN Press MENU and ENTER at the same time to:

SETPT

XX.XXX

FLOW XX.XXX

View the stroke position of the pump

ANALOG I/O

Show calibration and RAW data for analog inputs

DIGITAL I/O

Shows current status of digital inputs and outputs

Press DOWN arrow to see digital out #3

Press the MENU key to exit from any of these special screens.