Use Instructions

8
Install ramp (Optional)
Locate the electronics housing with
the QR code and choose one of the
other three sides to place the ramp.
Place feet in open holes of L-
brackets. Slide the front lip of the
ramp over the vertical leg of the L -
bracket.
7
Verify gateway
Verify that your gateway is
displaying a solid green light. It
needs to be within 350 feet of your
sensors, and takes roughly 5-10
minutes after turning the gateway
on. Ensure that your scale housing
(attached to the side of the scale
with a Pulsa logo, QR code, and tare
button) is directly facing the
gateway for best results. Click on
the circle icon in the top right of the
Pulsa dashboard to see the last time
the gateway saw your sensors.
6
Place your sensor
Place your scale underneath your
consumable product. Again, ensure
that your scale housing (attached to
the side of the scale with a Pulsa
logo, QR code, and tare button) is
directly facing the gateway for best
results. Within 5-10 minutes you
should see an update in the Pulsa
dashboard.
9
For questions, please contact us at [e-mail] or 888 . 259 . 1163
Tare sensor (if needed)
After completing setup, confirm the
sensor is level on a flat surface and
check the sensor reading with no
weight applied. If the reading is not
zero, press the tare button to re-
zero the sensor.