Data Sheet

ZM11.SIDE, ZM12.SIDE
ZM13.SIDE, ZM14.SIDE, ZM15.SIDE
Side Mounting Bracket
Oct. 2007 / Rev. 1.2 DS-ZMXX.SIDE-EN / All parameters are specified at 25°C ambient unless otherwise noted.
The information presented in this document is believed to be accurate and reliable and may change without notice.
www.pulspower.com Phone [phone] Germany
2/2
3. ASSEMBLY AND MOUNTING INSTRUCTIONS
Fig. 3-1 Detaching DIN-Rail brackets Fig. 3-2 Detach slide Fig. 3-3 Mounting steel bracket
Detach the two aluminium
brackets by removing the four
screws with a Torx screwdriver
(Torx 10). Save the screws for
step 3.
Remove the plastic lock
mechanism by using a flat-blade
screwdriver to move the lock
downwards while at the same
time push the plastic slide
upwards. Detach the plastic slide.
Mount the steel brackets with the
same screws from the DIN-Rail
brackets using caution not to
over-tighten the screws!
Recommended tightening torque
is 0.6Nm. (5.3lb.in).
Fig. 3-4 Panel Mount Fig. 3-5 DIN-Rail Mount
Two mounting options:
- Panel Mount
- DIN-Rail Mount
Preparation for DIN-Rail mounting:
Install the two aluminium brackets and the
plastic slide (detached from the unit before)
onto the side mounting plant with the
additional screws provided.
4. ORDER NUMBERS
Accessory
ZM11.SIDE
Side-mounting Bracket Kit 145x65x37mm
ZM12.SIDE
Side-mounting Bracket Kit 145x65x44mm
ZM13.SIDE
Side-mounting Bracket Kit 145x65x63mm
ZM14.SIDE
Side-mounting Bracket Kit 145x65x76mm
ZM15.SIDE
Side-mounting Bracket Kit 145x65x84.5mm