Data Sheet

ZM1.UBC10
WALL/PANEL MOUNTING BRACKET FOR UBC10 UNIT
Jan. 2010 / Rev. 1.0 DS-ZM1.UBC10-EN
All parameters are specified at 25°C ambient unless otherwise noted.
www.pulspower.com Phone [phone] Germany
ASSEMBLY AND MOUNTING INSTRUCTION
Step 1: Put the unit backwards on a flat surface and remove the fuse before working on the unit.
Step 2: Loosen the captive cover screw.
Step 3: Open the battery compartment.
Step 4: Remove the battery without disconnecting the connection wires.
Step 5: Put the ZM1.UBC10 bracket behind the unit.
Step 6: Screw the four screws and the four spring-lock washers, which were delivered with the mounting bracket,
into the shown areas. Tightening torque: 3 Nm (27 lb inch)
Step 7: Return the battery into the housing, close the battery compartment and insert the fuse again.
The information presented in this document is believed to be accurate and reliable and may change without notice.
No part of this document may be reproduced or utilized in any form without permission in writing from the publisher.
2/2