Cut Sheet

ML90.200
MiniLine
24V 3.75A, TWO-PHASE INPUT
ML90.200 Rev 1.0-EN / All parameters are specified at 24V, 3.75A, 400Vac and 25°C ambient unless otherwise noted.
www.pulspower.com Phone [phone] Germany
2/2
OUTPUT
Output voltage nom DC 24V
Adjustment range min 24V-28V
Factory set typ 24.5V
Output current nom 3.75A at 24V, 3.2A at 28V
Line regulation max 20mV 323…552Vac
Load regulation max 240mV static regulation
Serial use not allowed
Parallel use not allowed
Return voltage max 35V
OVP typ 34V
max 39V
Output voltage vs. output current, typ.
Output Voltage
0
024
4
8
12
28V
16
20
24
8A531 67
Adjustment
Range
Output Current
Output current vs. ambient temperature
Allowable Output
Current at 24V
0
-10 0 20 40
70°
C
1
2
3
4
5A
60
Ambient Temperature
Ambient temp. is defined 2cm below the unit
SAFETY AND PROTECTION
Input / output insulation SELV IEC/EN 60950-1
PELV EN 60204-1
3000Vac 2s type test
Degree of pollution 2 EN 50178
Degree of protection IP 20 EN/IEC 60529
Class of protection I PE required
Over-voltage category III EN 50178
Internal input fuse T3A15
in L1,
not accessible
Temperature protection not included
TERMINALS AND WIRING
Type Bi-stable, quick-connect spring clamp
terminals. Shipped in open position.
Solid wire 0.3-2.5mm
2
Stranded wire 0.3-2.5mm
2
AWG AWG 26-12
Stripping length 6mm / 0.25inch
Ferrules allowed, but not required
EMC
EMC Immunity EN 61000-6-1, EN 61000-6-2
EMC Emission EN61000-6-3, EN 61000-6-4
EN 55011, EN 55022, FCC-15
Harmonic input current EN61000-3-2 (PFC)
Flicker EN61000-3-3
APPROVALS
UL 508 Industrial Control Equipment
UL 60950-1 Information Technology Equipment
NEC Class 2 According to NEC (National Electrical
Code) Article 725-41 (4).
Listed as Limited Power Source (LPS)
in the UL 60950-1 UL report.
FULFILLED STANDARDS
EN 61558-2-17 Safety of Power Transformers
EN/IEC 60204-1 Safety of Electrical Equip. of Machines
EN/IEC 60950-1 Information Technology Equipment
EN/IEC 61131-2 Programmable Controllers
EN 50178 Electronic Equip. Power Installations
DIMENSIONS AND WEIGHT
Use 35mm DIN-rails according to EN 60715 or EN 50022 with a
height of 7.5 or 15mm. The DIN-rail height must be added to the
depth (103mm) to calculate the total required installation depth.
Weight max 360g 0.79lb
The power supply shall only be installed and put into operation by qualified personnel. This power supply is designed for installation in an enclosure
and is intended for the general use, such as in industrial control, office, communication, and instrumentation equipment. Do not use this device in
aircraft, trains and nuclear equipment, where malfunctioning of the power supply may cause severe personal injury or threaten human life. The
information presented in this document is believed to be accurate and reliable and may change without notice.