Data Sheet
Table Of Contents
- 1. Intended Use
- 2. Installation Instructions
- 3. AC-Input
- 4. DC-Input
- 5. Input Inrush Current
- 6. Output
- 7. Hold-up Time
- 8. Efficiency and Power Losses
- 9. Functional Diagram
- 10. Front Side and User Elements
- 11. Connection Terminals
- 12. Lifetime Expectancy
- 13. MTBF
- 14. EMC
- 15. Environment
- 16. Safety and Protection Features
- 17. Dielectric Strength
- 18. Approved, Fulfilled or Tested Standards
- 19. Regulatory Product Compliance
- 20. Physical Dimensions and Weight
- 21. Accessories
- 21.1. ZM1.WALL - Wall/Panel Mount Bracket
- 21.2. ZM12.SIDE - Side Mount Bracket
- 21.3. YRM2.DIODE - Redundancy Modules
- 21.4. YR20.246 - Redundancy Module
- 22. Application Notes
- 22.1. Peak Current Capability
- 22.2. Charging of Batteries
- 22.3. Series Operation
- 22.4. Parallel Use to Increase Output Power
- 22.5. Parallel Use for Redundancy
- 22.6. Use in a Tightly Sealed Enclosure
- 22.7. Mounting Orientations
CT5.241
CT-Series
3-PHASE, 24V, 5A, 120W
Aug. 2021 / Rev. 2.1 DS-CT5.241-EN All values are typical figures specified at 400Vac, 50Hz input voltage, 24V, 5A output load,
25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone +49 89 9278 0 Germany
21/28
21.2. ZM12.SIDE - SIDE MOUNT BRACKET
This ZM12.SIDE bracket is used to mount the device sideways with or without utilizing a DIN rail to
save installation depth.
The two aluminum brackets and the black plastic slider of the unit have to be detached, so that the
ZM12.SIDE steel bracket can be mounted.
For sideway DIN rail mounting, the removed aluminum brackets and the black plastic slider need to be
mounted on the ZM12.SIDE steel bracket.
Fig. 21-7
Side mounting
without DIN rail brackets
Fig. 21-8
Side mounting
with DIN rail brackets
Fig. 21-9
Hole pattern
All dimensions in mm