Datasheet

CP5.241, CP5.241-C1, CP5.241-S1,
CP5.241-S2, CP5.242
CP-Series
24V, 5A, 120W, SINGLE PHASE INPUT
Feb. 2018 / Rev. 0.3 DS-CP5.241-EN All parameters are typical values specified at 230Vac, 50Hz input voltage, 24V, 5A output load,
25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
P R E L I M I N A R Y
22.4. UF20.241 BUFFER MODULE
This buffer unit is a supplementary device for DC 24V power supplies. It delivers power to
bridge typical mains failures or extends the hold-up
time after turn-off of the AC power. In times when
the power supply provides sufficient voltages, the
buffer unit stores energy in integrated electrolytic
capacitors. In case of mains voltage fault, this energy
is released again in a regulated process. One buffer
module can deliver 20A additional current.
22/28
The buffer unit does not require any control wiring. It can be added in parallel to the load
circuit at any given point. Buffer units can be added in parallel to increase the output
ampacity or the hold-up time.
DC
Buffer
Unit(s)
Power
Supply
Load
AC
+
-
22.5. ZM6.WALL – WALL/PANEL MOUNT BRACKET
This bracket is used to mount the devices on a wall/panel without utilizing a DIN-Rail and can be mounted without
detaching the DIN-rail brackets.
Fig. 22-1 Isometric view
(Picture shows the CP5.241)
Fig. 22-2 Isometric view-
(Picture shows the CP5.241)
Fig. 22-3 Isometric view
(Picture shows the CP5.241)
Fig. 22-4 Wall/panel mounting, front
view (Picture shows the CP5.241)
Fig. 22-5 Hole pattern for wall
mounting
Fig. 22-6 Wall/panel mounting,
side view (Picture shows the CP5.241)