Datasheet

CP5.241, CP5.241-C1, CP5.241-S1,
CP5.241-S2, CP5.242
CP-Series
24V, 5A, 120W, SINGLE PHASE INPUT
Sep. 2018 / Rev. 0.4 DS-CP5.241-EN All parameters are typical values specified at 230Vac, 50Hz input voltage, 24V, 5A output load,
25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
PRELIMINARY
3. AC-INPUT
The device is suitable to be supplied from TN-, TT- and IT mains networks with AC voltage. For suitable DC supply
voltages see chapter 4.
AC input Nom. AC 100-240V
AC input range Min. 85-264Vac Continuous operation
Min. 264-300Vac Occasionally for maximal 500ms
Allowed voltage L or N to earth Max. 300Vac Continuous, according to IEC 60664-1
Input frequency Nom. 50–60Hz ±6%
Turn-on voltage Typ. 80Vac Steady-state value, see Fig. 3-1
Shut-down voltage Typ. 74Vac Steady-state value, see Fig. 3-1
External input protection See recommendations in chapter 2.
AC 100V AC 120V AC 230V
Input current Typ. 1.30A 1.09A 0.60A At 24V, 5A, see Fig. 3-3
Power factor Typ. 0.99 0.98 0.91 At 24V, 5A, see Fig. 3-4
Crest factor Typ. 1.7 1.8 2.2 At 24V, 5A, The crest factor is the
mathematical ratio of the peak
value to RMS value of the input
current waveform.
Start-up delay Typ. 420ms 400ms 385ms See Fig. 3-2
Rise time Typ. 80ms 85ms 90ms At 24V, 5A const. current load, 0mF
load capacitance, see Fig. 3-2
Typ. 100ms 100ms 110ms At 24V, 5A const. current load, 5mF
load capacitance,, see Fig. 3-2
Turn-on overshoot Max. 200mV 200mV 200mV See Fig. 3-2
Fig. 3-1 Input voltage range Fig. 3-2 Turn-on behavior, definitions
5/29
Turn-on
85V
Rated
input range
max.
500ms
V
IN
P
OUT
300Vac264V
Shut-down
Start-up
delay
Rise
Time
Overshoot
- 5%
Output
Voltage
Input
Voltage
Fig. 3-3 Input current vs. output current at
24V output voltage
Fig. 3-4 Power factor vs. output current at
24V output voltage
Power Factor, typ.
123456A
6A
0.51234
0
0.25
0.5
0.75
1.0
1.25
1.5A
Input Current, typ.
5
a) 100Vac
b) 120Vac
c) 230Vac
(a)
(b)
(c)
0.75
0.8
0.85
0.9
0.95
1.0
(a)
Output Current
Output Current
(a) 100Vac,
(b) 120Vac,
(c) 230Vac
(b)
(c)